Stainless steel railing posts for bar railing Typ SG02

Warning notices:

• Installation by qualified personnel only! We generally recommend that installation is carried out by trained specialists.
• Use suitable fastening material! Only use fixing materials that are suitable for your surface. Screws, dowels and/or heavy-duty anchors must match your floor and be suitable for stainless steel.
• Danger of falling! Always ensure suitable fall protection.
• Use filling segments! Please never install the post without filler segments, as these cannot be retrofitted. For design reasons, the post assembly and the installation of the filler segments are carried out at the same time.
• Follow the care instructions! Please note that stainless steel must be cleaned regularly and generally maintained. Otherwise the material may lose its rust-proof properties.
• Risk of rust! This stainless steel has only a low resistance to chemicals and acids in particular. For this reason, we advise against using it in aggressive environments, as it damages the corrosion protection and could lead to material failure. For example, use near pools, in cities with high levels of air pollution and in places in the immediate vicinity of the sea is not recommended!

Installation instructions:

Before starting installation, please read the following instructions carefully.

Post installation:

1. Place the first post in the desired position. Pay attention to the alignment of the handrail saddle and the filling segment holders. For each additional post, first slide a filler segment onto the previous post. Then slide the holders of the next post into the filler segment to determine the position of the post.
2. Carefully lift the cover grating from the post and mark the holes of the base plate on the floor.
3. Now place the post to one side.
4. Drill the marked holes and insert the selected fixing material according to the manufacturer's instructions.
5. Return the post to its position and hand-tighten the fixing material.
6. Align the post
7. Screw the post in place and observe any manufacturer's instructions for the mounting material. Ensure that the post remains aligned.

Attach the handrail:

Below we describe how you can attach a handrail to the post.

1. Place the handrail on the post and attach it to the saddle with adhesive tape.
2. Make sure that the handrail is aligned according to your wishes and that it is flush with the saddle.
3. Mark the position of the holes in the saddle on the handrail tube.
4. Remove the handrail from the post and place it on the shipping carton.
5. Now drill the threaded holes at the marked points on the handrail tube.
6. Place the handrail back on the post and screw it in place.

Care instructions:

Please note that the stainless steel post must be cleaned and maintained at regular intervals. If this maintenance is not carried out, or only insufficiently, the material may lose its rust-proof properties. You can use commercially available, non-acidic cleaning agents for cleaning. Please also note that the occurrence of occasional flash rust cannot be ruled out. Flash rust should be removed as quickly as possible to avoid any damage to the material.