French balcony made to measure
Our French balconies "Made in Germany" are made of stainless steel.
The qualitative processing provides a simple, timeless design and completes the appearance of a facade.
Due to the welding of the struts with the upper and lower chord, a higher stability is achieved here. The brackets for mounting are screwed to the 42.4x2 mm tubes. The diameter of the mounting plate is approx.100mm. The mounting is done by 2x 11mm holes.
Data:
- The length (width) can be selected from 500 to 2300mm as desired (50 to 230cm).
- For the height of the French balcony, there are three options to choose 900mm / 1000mm / 1100mm (90cm / 100cm / 110cm).
- The top and bottom chords have a diameter of 42.4mm and a wall thickness of 2mm.
- The connecting rods have a diameter of 12mm. Their number automatically adjusts to the selected length (width).
- The struts have a distance from each other of 120mm (12cm). Depending on the reveal dimension, at the respective ends the last strut can be closer to the edge or further from the edge. The distance does not exceed the 120mm.
- Cutting tolerances +/- 3mm
Important notes:
- Please do not make any additions or deductions to the dimensions.
- A data sheet with all the important information for installation can be found under PDF.
- If the French balcony is attached to an insulated façade, make sure to fix it into the masonry during installation.
- Observe the currently valid building regulations of your country.
- Please make sure that the enclosed fixing material corresponds to your installation conditions.
Watch your step! Kit means that you receive all components in one delivery. This will be completely prepared in our own workshop and then shipped to you for assembly.
How do I measure correctly?
Measure the reveal width with a folding rule or tape measure. ( measure A )
The distance to the fixing should be chosen so that the holes on both sides are at least 100 mm away from the reveal edge. ( Talk to your planner or architect if necessary )
