Handrail configurator
With the handrail configurator you can make bracket adjustments according to your wishes.
Application:
Step 1:
Select the desired number of holders as well as the end caps.
Step 2:
Select your handrail length with the slider or in the field above.
Step 3:
Position the brackets on the handrail.
To do this, you can either adjust the brackets on the handrail shown or enter the desired measurement in the fields below.
The measurement is taken from the left handrail end.
Step 4:
To make a holder extension or shortening, click in the "Use own measurements" box next to the holder you want to adjust. Enter your desired measurement. The modified holder is marked with a blue dot.
The dimension is measured from the centre of the holder.
Would you like to see how the holder would look on the wall? Change the perspective and see how the handrail would look on the wall.
Technical data
Handrail tube:
33,7 mm V2A stainless steel tube 1.4301 ground in grain 240
Wall thickness: 2 mm
Handrail support: standard size
angled
Height bracket: 75 mm
Length bracket: 75 mm
Diameter flange plate: 70 mm (with rosette)
Drill hole size in flange plate: 3 holes of 7mm each
Wall distance: standard dimension
33,7 mm = 56 mm (clear dimension)
End caps & cover rosette:
The end caps are pre-assembled and glued.
After screwing the handrail to the wall, the cover rosette can simply be slid on or secured by you with assembly adhesive or similar (not a must).
You do not want to have the end caps pre-assembled? Please note this in the comments field when ordering.
Tolerances:
+- 3 mm
Scope of delivery:
- Selected handrail in the desired length
- pre-assembled end caps and welded-on handrail brackets with cover rosette
- desired bracket configuration
