Stainless steel handrail V2A angled
Your individual handrail awaits you
You have full control over the composition of your individual handrail. You have the choice of the mounting side, the diameter, the end caps and where the handrail should be made angled. By specifying the dimensions, the handrail is adapted to your stairs in German quality and manual work in our locksmith's shop. To measure, simply follow the instructions in the respective variant articles.
Notes
The indication of the wall side must be viewed from below looking up the stairs.
The number of handrail holders used depends on the length of the handrail in the staircase:
| 0 - 2000mm |
2 Holder |
| 2001 - 3000mm |
3 Holder |
| 3001 - 4000mm |
4 Holder |
| 4001 - 5400mm |
5 Holder |
Please note the attached drawings in the variants for determining the required dimensions.
The maximum staircase dimension is 5400mm.
Should we discover during production that a too acute angle is a problem, you will be contacted by us.
The angled handrail pieces have a fixed dimension of 300mm each.
Please note our AGB's with regard to special designs.
Scope of delivery
- Handrail according to your specifications
- End caps are pre-assembled
- Handrail supports are welded on with cover rosettes
- Fastening material (3 screws & dowels per holder)
You need a holder extension? This is only possible with round holders. Simply send us an enquiry by email.
