Aluminium plate Checker plate Tear plate Duett
Material: Aluminium AW 5754 AIMg3
EN 1386 / EN 573-3
Features and Typical Applications:
seawater resistant ( DIN 81249-1 )
Offshore technology ( DIN EN 13195-1 )
very good anodising properties
good weldability
shipbuilding
food industry
vehicle construction
metal construction
tank construction
Thermosatbil for short exposure up to 160° C
Information:
Cutting tolerances for sheet metal: +/- 2mm.
Due to production, the products may have small scratches.
Caution, aluminium is a sharp-edged material. Please use appropriate protective clothing, we assume no liability for damage or injury.
Aluminium has only a third of the specific weight of steel.
Due to the low weight, massive energy and cost savings are possible in assembly, maintenance, transport and production.
Good conductivity for electricity m/O x mm² 20-25
Good thermal conductivity W/cm °C ~1.50
Cut to size:
The sheets are laminated on one side and may have scratches on the reverse side. The cut edges are not deburred!
The following tolerances apply to blanks and fabrications:
Length and width tolerance:
from 0 - 200mm: +/- 2,0mm
from 200mm - 2000mm: +/- 2,5mm
from 2000mm: +/- 3mm
